If you own a private workshopor an enterprise for the production of paving slabs, of course, you need to have a tool such as a vibrating table. With your own hands you will make it, or purchase a ready-made version in the store, it is not so important - the result and quality of the work will be almost on the same level.However, if your company's budget is materiallylimited, you do not have to do anything else, how to make this device with your own hands. That is why today we will consider how to make a vibrating table with minimal expenses of money and time.
To begin with, an image of the futureWith this you will produce a tile. As we know, the vibrating table performs one function - by its actions it throws out excess air from the concrete solution, due to which the composition of the tile or other concrete product becomes more durable.But that the quality of work is indeedsatisfied all expectations, it is necessary to draw up a drawing correctly. In the question "how to make a vibrating table with your own hands", the drawing must have the most accurate values and dimensions with all observance of the scale. However, it is not necessary to draw lines accurate to a millimeter.
Now go to work. Having become acquainted with the indications of the drawing, it is necessary to weld several corners with the size 60x60x5 mm with each other using a welding machine. At the same time, 4 bars are to be cut into the resulting frame and welded to the structure. They should be arranged symmetrically. At this corner of the frame base, it is possible to make cuts under 450for the reliability of the structure.
The top cover is, perhaps, the only onea mechanism that almost completely repeats the contours of the base of the device. Due to this, it is not very difficult to make a vibrating table by one's own hands. After the steel sheet is welded to the frame, proceed to install the motor (main vibrator). Yes, and install the OSB sheet between the frame and the sheet. This is done in order to remove unnecessary irregularities, welding traces or heads of fixing bolts.
Doing a vibrating table with your own hands, remember thatThe main part of this device is a vibrator - a small electric motor that rotates the surface of the device (leaf at the base) from side to side. Some craftsmen use the engine from old washing machines as a power unit, others buy a ready-made unit in the store. It is worth noting that the first option is not so reliable and durable. The maximum, as far as the motor from the washing machine was enough, is for 20-25 switching cycles. Further the motor demanded replacement (in its design the axle began to dangle, or the bearings were cleared). Therefore, for the production of paving slabs, it is best to buy ready-made vibrators in stores. Let them stand at times more expensive, but they will last you very, very long.